Most recent published dates first. Updated automatically from bounded verified sources. These listings are supplementary research, not individual VIN clearance.
Notice data may be incomplete or delayed by the original source. For individual applicability or repair status, contact the manufacturer or authority. Original reviewed guides are available in the journal.
In certain GLE series vehicles (model series 167) with OM654 and hybrid engines, a shielding plate in the bulkhead area may not have been fitted according to specifications. As a result, the fuel line could rub against the shielding plate and become damaged, causing a fuel leak. This may lead to a drop in fuel pressure and a loss of propulsion without warning, increasing the risk of an accident. The product does not comply wit
A defective weld on the ISOFIX bar may break in the event of an accident and increase the risk of injury to children in the child seat attached to it. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The rear brake calliper may become overloaded and break, which could lead to an accident and injuries This product does not comply with the Regulation on the approval and market surveillance of two- or three-wheel vehicles and quadricycles.
Affected vehicles may contain a suspect HV (high voltage) battery module manufactured by the supplier during a specific production period. It is recommended that the vehicle is to be parked in a well ventilated area. The vehicle can be used as normal. Remedy: Replacement of the high voltage battery module will be carried out.
On affected vehicles during freezing temperatures or below the windshield wipers may become inoperative. In other cases the windshield wipers may operate only at the high-speed setting and an inoperative windshield washer system may prevent washer fluid from being effectively used to clean the windshield. Remedy: Inspect the windshield wiper system and replace the wiper motor if necessary.
Affected vehicles may have Vehicle Supervision Module (VSM) software that displays incorrect speed-limit indications resulting in non-compliance with applicable regulatory requirements. Remedy: Update the VSM software and update the In-Vehicle-Infotainment software via Over-The-Air at the dealer if necessary.
On affected vehicles it may be possible that one or more engine camshaft roller finger followers were not properly installed at the time of assembly. An improperly installed camshaft roller finger follower may result in engine failure resulting in a no-start condition or a loss of motive power. Remedy: Replace the engine.
The ball joints on the steering rods may have insufficient hardness, which could cause them to break. This may affect vehicle handling and increase the risk of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The rear brake calliper assembly may crack and break under excessive stress loads.
The rear brake calliper assembly may crack and break under excessive stress loads.
Due to a quality deviation by the supplier certain battery cells within the High Voltage Battery System Assembly manufactured in limited production periods may have been produced with a misaligned electrode. A misaligned electrode may over time result in an internal short circuit in certain situations thereby increasing the risk of fire. Remedy: If the HV battery State of Health is greater than 90% Kia UK will replace the d
Affected vehicles may have a panoramic roof with an improper adhesion bond. This could result in wind noise water leak or separation from the vehicle. Remedy: Test the adhesion bonding of the panoramic roof. and replace if necessary